Security Sensors
The Security sensor is a magnetic on/off switch
which is used as an input to the sensorProbe.
Security Sensors come in pairs. They are active
switches that close when one half of the sensor
is in close proximity to its mate. When the two
sensor pairs are moved apart from each other they
open. The sensorProbe senses closure and opening
and reports the condition.
Security Sensors can be wired in series so
that multiple sensors can use a single port
on the sensorProbe. There are no reasonable
limits on the distance of the security sensors
from the sensorProbe. Security sensor with an
ALARM/NORMAL indication in software. Can have
an unlimited number of security sensors. Security
sensors can detect doors, windows. SNMP interface
for alarm/normal status. SNMP traps sent when
critical. SNMP polling via get available. Web
browser interface available. When an alarm condition
is activated the description and location of
the fault can be sent via email, page.
Specifications & Features:
Measurement range - Alarm or Normal
Communications cable - RJ45 jack to sensor using
UTP Cat 5 wire,
Maximum extension cable length 305m (1000 ft.)
with approved low capacitance shielded cable
or UTP.
Sensor type - open/closed contact switch
Power source: powered by the sensorProbe. No
additional power needed
sensorProbe autodetects the presence of the
security sensor
Measurement rate - multiple readings every second
Up to 2 security sensors per sensorProbe2, 8
per sensorProbe8 and cameraProeb8
Full autosense including disconnect alarm |
